David, he is thinking of the MGB -- it does require shims.
Mike
-----Original Message-----
From owner-spridgets at autox.team.net
[mailto:owner-spridgets@autox.team.net]On Behalf Of DLancer7676@cs.com
Sent: Tuesday, September 10, 2002 1:10 PM
To: undisclosed-recipients: ;
Subject: Bearing spacer shims
While I am waiting on my newly rebuilt head to arrive, I jacked all fours up
on the Midget and decided to do a brake job, plus check everything else out.
Also pull the wheel bearings , disassemble them, clean them, repack and
reassemble them.
Of course inside the front wheels are the familiar spacers. Before I pulled
the bearings out, I stuck my finger inside the wheel and could fairly freely
move the spacer about. My question is guided by a comment made by the
extremely experienced mechanic whom I consider a British car guru. He said
there should be some very thin shims on one side or the other of the
spacers.
There were none there--is it possible the DPO forgot to replace the shims?
Where can shims be gotten? I checked the Moss catalog blow ups and there
are
none listed or pictured. The mechanic said the shims were there to provide
a
means of tightening the wheel nut so the wheel would not be riding just on
the bearings.
--David C.
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|