In a message dated 11/25/02 9:17:00 PM Pacific Standard Time,
macy@bbl.med.upenn.edu writes:
> Allen H put a more modern fuse panel in his car, but I would rather stick
> with the 4 fuse style. I have had the block out and cleaned it using baking
>
> soda and a wire brush, as much as is possible. I think that it is getting
> too hot due to a bad connection between the spade and the rivet.
>
> So now comes the question, What are folks experiences with replacement fuse
>
> blocks?? Moss has them for $28 bucks. Thinking on going with that, just to
> get one.
>
> What sayeth the list??
- - - - - - - - - - - -
Well, THIS part of the list says to go to Slep Boys and buy the Littelfuse
spade block that I bought! 5 fuses gives you one for the headlights! They
are less than ten bucks and you can get fuses at Wawa.
I agree with your assessment about the melting. That is usually caused by a
loose connection, and there aren't may connections. It probably is a loose
rivet.
Allen Hefner
Phila. Region SCCA Rally Steward
'77 MG Midget (#51 FSP)
'75 MG Midget (The Project)
'92 Mitsubishi Expo LRV Sport
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|