Brad,
Your setup is correct but there was a changeover for the shim
placement to the opposite side for later cars beginning with
GAN5-114487. This coincides with the changeover from the Morris Minor
rack to Triumph rack. If David switched racks however, which I seem
to recall he either did or was considering, then this could be part
of the problem.
Gerard
At 8:57 PM -0500 8/10/03, Brad Fornal wrote:
>DLancer7676@cs.com wrote:
> So trying to reassemble it, the pinch fitting still balks at going
>onto the steering
>rack shaft. I did install (this morning) the distance piece on the
>left (driver's)
>side of the rack to try to straighten everything up. Should the
>steering column be that
>difficult to slide over the shaft?
>
>> Ok, maybe it's just my cars, but I went out to one of the 65's
>>and the distance
>> peice is on the side OPPOSITE the where the steering shaft goes.
>>On a RHD car, it
>> goes on the left side, and vice versa. Try that, and I believe
>>your problems will be
>> solved, on this problem that is.
>
>Brad
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|