spridgets
[Top] [All Lists]

Re: master cylinder rebuild

To: john.dagostino@comcast.net, spridgets@autox.team.net
Subject: Re: master cylinder rebuild
Date: Fri, 5 Sep 2003 23:04:19 EDT
In a message dated 9/5/03 8:39:06 AM Pacific Daylight Time, 
john.dagostino@comcast.net writes:


> My snap ring pliers can't 
> get a good grip on the snap ring down in the bore. Is there a special set of 
> pliers or some trick to removing it?
> 

John:

I took a cheap pair of needle nose pliers to my grinder and ground the length 
of them down until they were very slim and flat.  Then a slight groove in the 
outside of each tip and they fit right in there and squeeze the snap ring 
enough to remove.

--David C.


///  unsubscribe/change address requests to majordomo@autox.team.net  or try
///  http://www.team.net/mailman/listinfo
///  Archives at http://www.team.net/archive


<Prev in Thread] Current Thread [Next in Thread>