spridgets
[Top] [All Lists]

Re: Intake

To: Bill L <pythias@pacifier.com>
Subject: Re: Intake
Date: Sun, 6 Jun 2004 19:03:18 -0400 6.0.1|February 07, 2003) at 06/06/2004 07:33:05 PM, Serialize complete at 06/06/2004 07:33:05 PM
Cc: spridgets@autox.team.net
I had a single SU on my Sprite, but had a lot of trouble getting the set 
up to run rich enough throughout the entire range.  One thing I really 
liked was the ability to put a ram pipe on the single.  When you get 
length correct you can definitely feel it in the seat of your pants.

I eventually went back to a modified dual SU setup because I would rather 
sacrifice a little power than burn a piston from running lean at wide open 
throttle.

Tommy 
67 Sprite
60 MGA hot rod project

Please Note: This transmittal, and any attachments, may contain
confidential and/or privileged information which is the property of
Mark IV Automotive/Dayco Products, LLC and is for the sole use of the
intended recipient. If it is not clear that you are the intended recipient,
you are hereby notified that you have received this transmittal in error.
Your use, forwarding, printing, storing, disseminating, distribution, or copying
of this transmittal is strictly prohibited. If you suspect that you have 
received
this transmittal in error, please contact the sender immediately and delete 
this 
transmission and any attachments.






<Prev in Thread] Current Thread [Next in Thread>