spridgets
[Top] [All Lists]

Re: stronger main cap bolts

To: <roadandtrack@hypermax.net.au>, "FOT" <fot@autox.team.net>
Subject: Re: stronger main cap bolts
From: "rob" <19to1tr6@comcast.net>
Date: Mon, 18 Apr 2005 21:40:28 -0400
Delivered-to: mharc@demo.fatchancegarage.com
References: <000501c5447d$8e342530$6501a8c0@purplebox>
Reply-to: "rob" <19to1tr6@comcast.net>
Sender: owner-fot@autox.team.net
Terry what time and day is ti down there it's Monday 9:45pm on the east coast USA here
----- Original Message ----- From: "Terry and Cindy" <Roadandtrack2@hypermax.net.au>
To: "'rob'" <19to1tr6@comcast.net>; "FOT" <fot@autox.team.net>
Sent: Monday, April 18, 2005 9:17 PM
Subject: RE: stronger main cap bolts


Interesting reading

Does anyone have any real data on the yield strength of the bolts being
suggested versus stock ones??.

I have been caught before. I am using some Mitsubishi conrods in a
stroked 2 litre GT6 racer. I had their bolts tested to find they are the
same yield strength as the fancy ARP ones.

I have built dozens (maybe hundreds) of road & race triumph engines over
30 years and never seen a main bearing bolt fail. I've tossed out quite
a few from thread damage or other visible defects, but the majority are
fine.

Further, with regards to 'aircraft" bolts, many are a grade of stainless
steel which can be quite brittle, and are not suited to this type of use

Does anyone have any real data to share??

thanks

Terry O'Beirne





<Prev in Thread] Current Thread [Next in Thread>