Looks like they should fit fine in the green one in the center!!
On Apr 29, 2005, at 10:13 AM, Robert Duquette wrote:
> And the reason I ask, is because I seem to have screwed up and I
> may have decisions to make.
> To try and keep this as concise as possible, I bought a Maniflow
> intake from APT and had it machined there.
> When I sent David the link to the K&Ns the other day, he said
> something to the effect of "wait a minute. Do you currently have a
> Mini 30 degree intake installed?" I haven't checked that out yet,
> but, if I install the 20 degree intake then my SUs will move . . .
> probably out of the existing hump. :(
> hump ( if you have good eyes and monitor )
> Of course, where did those SUs come from then. I have to keep the
> floats level, don't I? I guess that determines how they mount. I
> may have just bought some scrap metal. The SUs are supposed to be
> from a UK spec MGB. What angle are they supposed to mount at?
> Now, the obvious first thing to check is the existing intake to
> find out what it really is. If I only had more than 5 minutes at a
> Our basement is in week 8 of an estimated 2 week repair with about
> 2 and a half weeks remaining. Chaos!
Larry B. Macy, Ph.D.
Department of Psychiatry
University of Pennsylvania
3400 Spruce St. - 1015 Gates
Philadelphia, PA 19104
I have great faith in fools - my friends call it self-confidence.
- Edgar Allen Poe
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.
MailScanner thanks transtec Computers for their support.