Paul
I swapped the working left side bulb for the non-blinking right side
bulb. The right side bulb works in the left socket, the left bulb does
blink in the right socket. So I would not think the problem is with the
filaments.
Dumb question - the bulbs has 2 little 'tits' (technical term I'm sure)
on the base which makes contact with the 2 wires in the socket. I've
always assume the 2 make a complete circuit flowing to and from bulb. Or
is 1 wire connection for running light filament and 2nd wire for
blinking filament?
Thanks again,
Jim
Paul Asgeirsson wrote:
>Have you checked out both filaments as OK?
>
>Pa
>
>----- Original Message -----
>From: "Jim Rogers" <JARplanner@cox.net>
>To: "Frank Clarici" <spritenut@comcast.net>
>Cc: "Spridget List" <spridgets@autox.team.net>
>Sent: Thursday, October 26, 2006 4:25 PM
>Subject: Re: Turn Signal
>
>
>
>
>>The front running lamp (sidelamp) lights up - so would it still be a bad
>>ground? I would think not.
>>
>>I've played with socket, but will try again.
>>
>>Thanks,
>>
>>Jim
>>
>>Frank Clarici wrote:
>>
>>
>>
>>>Jim Rogers wrote:
>>>
>>>
>>>
>>>>Right front turn signal does not blink.
>>>>
>>>>
>>>Bum ground at the lamp, or a bad socket, try wiggling the bulb, it it
>>>helps, try Koppershield or clean/fiddle with the socket.
|