spridgets
[Top] [All Lists]

Re: [Spridgets] Datsun Rebuild

To: "David Lieb" <dbl@chicagolandmgclub.com>, "Spridgets"
Subject: Re: [Spridgets] Datsun Rebuild
From: "Peter Shull" <pdx.pete@verizon.net>
Date: Mon, 19 May 2008 18:57:22 -0700
Okay ... I peeked. It's easier to access on-line than it is to wade through 
the pile of book in which the Datusn manual resides.

Standard baulk-ring-to-cone clearance: 0.0433 - 0.0551 (1.10 - 1.40 mm)

Thanks for the link ... I did not know it existed.

Pete


----- Original Message ----- 
From: "David Lieb" <dbl@chicagolandmgclub.com>
To: "Spridgets" <spridgets@autox.team.net>
Sent: Monday, May 19, 2008 5:46 PM
Subject: Re: [Spridgets] Datsun Rebuild


>> As a side note, I'm thinking that the minimum tolerance for a baulk ring,
>> once it is pushed down against the gear, is something like 0.40 or 0.41.
>> Don't quote me on that ... it's just that I am too lazy to go look it up
>> right now.
>
> BTW, Rivergate has a decent-quality scan of the manual at
> http://www.rivergate5speed.com/transmission_book_300dpi.pdf
> http://tinyurl.com/5ub2ny
> _______________________________________________
> Support Team.Net  http://www.team.net/donate.html
>
> You are subscribed as pdx.pete@verizon.net
>
> http://www.team.net/archive
>
> http://autox.team.net/mailman/listinfo/spridgets
_______________________________________________
Support Team.Net  http://www.team.net/donate.html


http://www.team.net/archive

http://autox.team.net/mailman/listinfo/spridgets

<Prev in Thread] Current Thread [Next in Thread>