I would assume that the degree of inclination of the frame rail would
match the caster angle. I suspect a frame repair technician would
bend the frame until he reached the specified caster angle.
On Fri, Dec 19, 2008 at 4:06 PM, Peter Caldwell <peter@nosimport.com> wrote:
> At 02:43 PM 12/19/2008, Trevor Jessie wrote:
>>
>> Take a look through these pictures:
>>
>> http://www.britishv8.org/Articles/BritishMotorHeritage-Midget.htm
>
> ===============
> That's very cool. In the 3rd picture, where they are showing the 1500
> engine support, note the toggle clamps. If the bulk of the frame is resting
> on the table, I would estimate the front of the horns to be raised about an
> inch? I'm comparing bolt diameters in the picture.
>
> Also, is the radiator support perpendicular to the frame or do they tilt
> back?
>
> Peter C _______________________________________________
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|