spridgets
[Top] [All Lists]

Re: [Spridgets] Now it starts

To: <spridgets@autox.team.net>
Subject: Re: [Spridgets] Now it starts
From: <corvallis@peoplepc.com>
Date: Thu, 29 Jan 2009 15:22:43 -0800
Thanks for sharing. Always something.

-----Original Message-----
From: spridgets-bounces@autox.team.net
[mailto:spridgets-bounces@autox.team.net] On Behalf Of Frank Clarici
Sent: Thursday, January 29, 2009 3:10 PM
To: Spridgets
Subject: [Spridgets] Now it starts

And runs well.
Turned out to be the header was keeping the bottom of the intake from 
sealing.
In pulling it off to check to see if I pulled out all the paper towels 
keeping dirt out of the engine...
I knew I pulled them out but did I forget one?
Turns out, no, I didn't leave any towels in the holes. But Brian noticed 
that there was a paint mark on one hole of the gasket but not the other. 
Turns out the intake was rocking on the center header pipe, not so much 
the intake but the heat shield.
Some strategic blows with a BFH fixed it right up. It ran long enough to 
set the carbs, now it runs well.
I knew it was acting like a major intake leak but the nuts were tight, 
the manifold was not damaged, who would have thunk it?

-- 
Frank Clarici
Toms River, NJ
_______________________________________________
_______________________________________________
Support Team.Net  http://www.team.net/donate.html


http://www.team.net/archive

http://autox.team.net/mailman/listinfo/spridgets

<Prev in Thread] Current Thread [Next in Thread>