Yes, but if you have a clearance issue with the top of the tunnel, you won't
be able to slide it forward, which was my experience. The way you describe
was the way I installed it.
Mike MacLean
On Fri, Mar 20, 2009 at 11:18 AM, Bill L <pythias@pacifier.com> wrote:
> Hello rrengineer,
>
> When I put in the driveshaft, I just reach down the shifter hole
> and pick up the yoke and start it on the output shaft.
>
> And then there's the masking tape method.... ..
>
> no need to cut and weld OR fight the whole assembly as one piece
>
> --
> Best regards,
> Bill L. mailto:pythias@pacifier.com
>
> '66 Sprite MKIII HAN8L49403 "the red thing"
>
> Xerox never comes up with anything original.
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|