spridgets
[Top] [All Lists]

Re: [Spridgets] Crankshaf tpulley bolt

To: spridgets list <spridgets@autox.team.net>
Subject: Re: [Spridgets] Crankshaf tpulley bolt
From: brian S <bugeye15@hotmail.com>
Date: Tue, 16 Jun 2009 09:56:05 -0400
Leo,

I did mine in Frank's driveway a month ago.
As larry said, if you take the pan off,
put a 2x4  between the block and crank.
Or as I did, use a breaker bar, put it against
the frame, and bump the starter to break it loose.

Brian S.
Bugeyeracer finally resto'ed!



> From: 60bugeye@cebridge.net
> To: spridgets@autox.team.net
> Date: Mon, 15 Jun 2009 22:26:24 -0500
> Subject: [Spridgets] Crankshaf tpulley bolt
>
> Any one have a good way to hold the crank pulley while breaking the
> crankshaft bolt loose?  I have to change out the front seal.  Am going to
> replace the timing cover also with one that takes the neoprene seal versus
> the original felt one.  Have a major oil leak there and am not going to have
> it again due to the felt seal.  Prefer a method which does the least damage
> to paint:)  Am also going to drop the pan and check out the rod bearings to
> see if  they might be the culprit in my low oil pressure.
>
> leo


_________________________________________________________________
Lauren found her dream laptop. Find the PC thats right for you.
http://www.microsoft.com/windows/choosepc/?ocid=ftp_val_wl_290
_______________________________________________
Support Team.Net  http://www.team.net/donate.html


http://www.team.net/archive

http://autox.team.net/mailman/listinfo/spridgets

<Prev in Thread] Current Thread [Next in Thread>