spridgets
[Top] [All Lists]

[Spridgets] Wanted:- Advice on re-doing a cylinder head...

To: spridgets@autox.team.net
Subject: [Spridgets] Wanted:- Advice on re-doing a cylinder head...
From: "Dave G." <kk7ss@verizon.net>
Date: Thu, 23 Jul 2009 11:37:02 -0700
After the usual assortment of "Aw Shit's" and "Damn's" plus a few 
other choice words, I have determined that #2 inlet guide is worn 
enough to admit oil into the combustion chamber...

I have been working (slowly!) on re-doing a spare head.
It's been cleaned, valves, springs, guides are all fitted - just 
needs the rocker assembly from the head that's still on the motor...

Here's the question: after all this time, even though it's been in 
the house all this time,  the surface of the replacement head has 
taken on a very thin 'sheen' of rust.

Would it be OK to just give the milled surfaces a quick wipe-over 
with 000 wire wool?? And could I then just paint the outside (rough) 
surfaces with Krylon spray paint??
Or ????
 
Thanks in advance... ;-))

--
Dave G.   KK7SS
'65 MK III Sprite in Richland, WA

If I wake up in the morning, and I hurt, it means that I'm still 
alive !!
_______________________________________________
Support Team.Net  http://www.team.net/donate.html


http://www.team.net/archive

http://autox.team.net/mailman/listinfo/spridgets

<Prev in Thread] Current Thread [Next in Thread>