There is a type of freeze plug that is a piece of rubber between two large
(fender) washers. There is a bolt sticking thru the outside that is
tightened down. This squishes the rubber out to hold the freeze plug in its
hole. ...bill in oregon
============================================================
-----Original Message-----
From: spridgets-bounces@autox.team.net
[mailto:spridgets-bounces@autox.team.net] On Behalf Of Greg Higgins
Sent: Sunday, July 26, 2009 7:41 AM
To: spridgets@autox.team.net
Subject: [Spridgets] blown frost plug
I was driving my sprite the other day on a nice quiet country road, the
weather was prefect, I was thinking to myself the car is running great. Then
a
loud bang from under the hood, and some steam. I pulled over, popped the
hood,
and saw #2 frost plug was gone. A nice older couple pulled over and drove my
wife and I to the nearest town, and a tow truck.
A 100 mile tow equals $420.00, a few months before my wife cancelled the
extended coverage with C.A.A., we now have the extended coverage back.
I had removed all of the frost plugs a couple of years ago, the block was
boiled, and the engine was freshened up. I used some automotive silicone on
the new frost plugs. My question, should I install the new frost plug dry,
or
try the silicone again?
Thanks for any info
Greg Higgins
63 sprite
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|