Looks good Guy I'll try it.
Thanks Lin
On Tue, Oct 27, 2009 at 3:24 AM, Guy R Day <grday@btinternet.com> wrote:
> Linda,
>
> Is it this one?
>
> http://www.mtmc.co.uk/prodtype.asp?cookiecheck=yes&PT_ID=12707432
>
> If you go to http://www.mtmc.co.uk/ and follow the links you'll find
> quite a few listed.
>
> http://tinyurl.com/yfkvmud
>
> will take you to a UK Black & Decker listing that may show an exploded view
> you could use as a format for the rebuild.
>
> One of my favourite 'tricks' is to replace the brushes the wrong way round
> and one of the corners between the side and working surfaces wedges between
> one of the armature gaps. (red face!) You could try lifting the brushes
> and seeing if it spins....
>
> Best of luck,
> Guy R Day
>
> ----- Original Message ----- From: "Linda Grunthaner" <
> grunthaner@gmail.com>
> To: "Spridget list" <spridgets@autox.team.net>
> Sent: Tuesday, October 27, 2009 1:51 AM
>
> Subject: [Spridgets] Not LBC, tool assembly drawings for tool repair needed
>
>
> List,
>> I have looked for months and I can't locate the exploded view of an old
>> (30
>> years) Black & Decker circular saw of mine. It was my dads and I took it
>> apart and can't get it back together to where it spins by hand. I am not
>> 100% sure I have it together correctly so I need the drawings. Does anyone
>> know of an old tool repair shop or site I can get that from? The saw works
>> fine I overlooked a split in the wire before I took it apart. If it wasn't
>> my dads I would have made a lamp out of it by now but I am somewhat
>> determined to get it together correctly because it worked great days
>> earlier.
>> Lin
>> PS With all these throw away tools from Harbor Freight these days all the
>> repair shops are gone.
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|