After that I'd fabriacate a flat metal plate to bolt over the inlet/exhaust
ports and fasten it using a new gasket. If the head is off it then duct
tape on the block will provide an air tight seal.
Weslake-Monza 1330
In a message dated 01/09/2010 03:38:33 GMT Daylight Time,
spritenut@comcast.net writes:
I would start it up before you put it away just to get the oil flowing
to all the places it needs to be.
_______________________________________________
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|