Solder fuel tanks, don't weld them. Do not use an open flame. I put baking
soda and vinegar in a fuel tank after I wash it out. It fills the tank with
CO2. That leaves the tank with no oxygen to support combustion.
When I was much younger, I brazed up a hole in a 2 month old XKE fuel tank.
I used the baking soda and vinegar trick. Sure did clear out the shop. :-)
Soldering is MUCH safer.
Jim
-----Original Message-----
From: spridgets-bounces@autox.team.net
[mailto:spridgets-bounces@autox.team.net] On Behalf Of Jim Johnson
Sent: Tuesday, July 26, 2011 10:58 PM
Cc: spridgets@autox.team.net
Subject: Re: [Spridgets] Gas Tank?
Assuming these tanks are much like motorcycle tanks I've worked on DO NOT
ATTEMPT TO WELD ON IT UNDER ANY CONDITIONS!!! Even after being rinsed out
numerous times, they are still ticking time bombs. Frank used to boil his
out on the barbie... Only way I can think of to be certain there isn't the
slightest vestige of gas left in them and even that is too dangerous for my
blood!!
Cheers!!
Jim
_______________________________________________
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|