That's the kind of solution I was thinking about.
I wonder if the Honda bearing would fit in the Spridget throwout.
I think if I were to do something like that I would turn it in the lathe
(make a sleeve if needed) and then use Locktite retaining compound to
hold it together.
Thanks for posting.
-----Original Message-----
From: spridgets-bounces at autox.team.net
[mailto:spridgets-bounces at autox.team.net] On Behalf Of Tim Collins
Sent: Tuesday, November 29, 2011 2:32 PM
To: spridgets at autox.team.net
Subject: [Spridgets] Roller Throw out bearing
Check out the D.I.Y. roller throw out bearing over at the MG Experience.
<http://www.mgexperience.net/article/diy-roller-throwout-bearing.html>http:/
/www.mgexperience.net/article/diy-roller-throwout-bearing.html
|