[Top] [All Lists]

[Spridgets] fulcrum pin bushings

Subject: [Spridgets] fulcrum pin bushings
From: refisk at chartermi.net (Rick Fisk)
Date: Sat, 2 Jun 2012 18:58:50 -0400
References: <bc1d0eb2f538208e5abf22a4da1fcfed.squirrel@virtwebmail.nhvt.net>
You don't want to do this with the coil spring in place.  Block the rear
wheels and raise the car up and put two jackstands under the front
crossmember.   If your car has front disk brakes unbolt the caliper from the
spindle and tie it up out of the way.  Put your jack under the a-frame and
raise it until the a-frame starts to move up and the shock link is off of the
bumper.  Then remove the upper trunnion bolt.  Now remove the cotter and
fulcrum pins and kingpin and spindle assembly.

Slowly lower the jack until the a-frame drops all the way.  Then you can lever
or kick the spring out.  Now the inner bushings are easy to get at.

When you're ready to put it back together remove the spring pan from the
a-frame.  Bolt the a-frame in and install the kingpin spindle assembly with
your new fulcrum pin.  Bolt the kingpin trunnion to the upper shock link.
Then slide the spring up through the a-frame with the spring pan on the bottom
and your jack underneath.  Slowly raise the jack until you can get the pan
bolts in.  You might want to use some long bolts to temporarily pull the
spring pan up until you can fit the stock bolts.

Easier than it sounds, but it's still a long process.  :-)

Sent from my keyboard

On Jun 2, 2012, at 3:41 PM, lindalnhvt at nhvt.net wrote:

> Hi Everyone,
> First weekend off in 9 weeks and it's pouring rain so I'm working on the
> Sprite and need some advice.
> I have new bushings and fulcrum pin to install. I have a spring
> compressor, but it won't fit. I have the car on a jack stand and a jack
> under the A-arm which compresses the spring. If I jack higher, it lifts
> the car off the jackstand. I don't know if this is enough to unbolt and
> remove the fulcrum pin and bushings. Any suggestions from those of you who
> have done this before?
> Thanks.
> Dick Byrne in NH
> ------------------------

<Prev in Thread] Current Thread [Next in Thread>