On the 66 eBay Sprite, the original right wing (US passenger side) was
replaced. This one is off a later car, so the metal tang that the prop rod
fits into was never there. I have a small bit of stainless sheet, and will
make one, that I can bolt onto the inner lip.
My question is, if any of you guys were to do this, would you put it back
where it was from the factory? OR, since it isn't even the correct wing for
this car (for you concours folks) would you set it back further, to allow
the bonnet to sit open higher?
AND if I WERE to let it sit open higher, can anyone think of any issues
that may arise from that modification, other than the wind will catch the
bonnet easier?
DON JULIO 1942
http://tequilabrad.com/
------------------------
spridgets@autox.team.net
Archive: http://www.team.net/archive
|