I'm re-posting a segment below of "underneath", installment 12, on a
subject I could still use some advice on. Thanks.
"One part not on the x-member is the brake line going to the left
caliper. I got a set of bendemyourselfs from TTMS, and tried to match up
the bends in the old line, which I had found dangling from the car still
bolted to the so-called "5-way" connector. That looked neat until I
started looking at where it attaches to the car. The old line, and my
copy, follow the inside curve of the x-member where it's clipped in
place, and then comes upward, reasonably sharply, and then ends facing
rearward, in the vicinity of the RR x-member mounting bolt hole. The
problem? The "5-way" on the car is directly above the RF x-member hole;
what, 6-8 inches further forward? How do I route the brake line all of
the way up there? The manual doesn't have a picture of the brake lines.
I really could use a bit of advice on this."
Lawrence R. Wright
Purchasing Analyst
Andrews Office Products Div. of USOP
larry.wright@usop.com (new)
Ph. 301.386.7923 Fx. 301.386.5333
|