tigers
[Top] [All Lists]

RE: New RED Paint....

To: DrMayf <drmayf@teknett.com>, land-speed@autox.team.net,
Subject: RE: New RED Paint....
From: Theo Smit <theo.smit@dynastream.com>
Date: Fri, 11 Jul 2003 08:23:05 -0600
Make sure you use a hard rubber sanding block. 320 grit silicon carbide
wet-or-dry paper is going to remove the paint pretty quickly, and using
the block will help make sure you remove the high spots first, anyway.

Red paint should have a very high pigment content, but even so it will
be necessary to do two or three wet coats to cover the color underneath.
If you didn't do a full primer coat underneath then it will take a
couple more coats to really get even coloring.

Theo

-----Original Message-----
From: owner-tigers@autox.team.net [mailto:owner-tigers@autox.team.net]On
Behalf Of DrMayf
Sent: July 11, 2003 7:45 AM
To: land-speed@autox.team.net; tigers@autox.team.net; Alpine Mailing
List
Subject: New RED Paint....


Well, yesterday, I sprayed paint on the SUnbeam shell. Awful results, in
my
opinion. So this morning I am going to wet sand the entire car to remove
the
nasties. Almost seems like this paint did not have enough pigment in it
and
is almost translucent. The grabber blue I sprayed in the cockpit seemed
to
be great, even though I missed a few spots. The car is naturally pitted
in
many places and I am ok with that but the other ...ugh. Color is ok,
though.

I have some 300 grit or is this too coarse?

mayf

<Prev in Thread] Current Thread [Next in Thread>