Listers,
I am trying to design a mount for a non-stock fuel pump under my car in
generally the original location. Has anyone done this already as I am a
little perplexed as to how to mount the assemblies and still maintain a
rubber mount. I do not want to mount it in the trunk. I am planning to run
an Earls Pre-filter and Aeromotive pump and a Fram HPG-1 final filter. Any
good installs would be really appreciated and photos would be best. I do
recall someone on the list built a drop in fuel pump and filter assembly and
I would LOVE a photo or two of that.
I have already built the carb set up with the regulator using 3/8 tube and
some $tainle$$ bi-lok fitting$$ drilled out to an inside diameter of 5/16
inch (same id as 3/8 steel tube) 3/8 aluminum tube is smaller ID. Entire
assembly is clean and includes a regulator and a gauge and fits under the
Ram Air box.
Best Regards,
Tim Ronak
Business Development Manager
Akzo Nobel Coatings
23961 Via El Rocio
Mission Viejo, CA 92691
Off: (949) 305-5393
Fx: (425) 955-6268
Cell: (949) 289-3357
email: timothy.ronak@akzonobel.com
VM: (800) 234-6747 ext. 2257#
This message, including attachments, is confidential and may be privileged.
If you are not an intended recipient, please notify the sender then delete
and destroy the original message and all copies. You should not copy,
forward and/or disclose this message, in whole or in part, without
permission of the sender.
|