Hi Walley, one very important step is to drill the stud holes for the
tonneau cover down through the second layer of sheet metal and into the area
behind the dash. this way, when the dash pad is in place, the drill can be
run up through the the dash pad from the bottom and relocate the stud
positions.
I trimmed the dash after it was installed. Robin Yooung
I'm at the point of putting a new top dash pad in place, and it looks like a
tricky little job at best, where you only get one shot at it. If anyone has
any advice or instructions on the best way to do this it would be greatly
appreciated.
|