"small" is relative, depending on the perception of the DPO and their
ability to hit the right spot the first time... Some Tigers have "small"
user-installed holes in the transmission tunnel to aid in
block-to-bellhousing bolt removal (to allow in-the-car
engine/transmission separation). Mine had a 3" square hole on the left
side of the tunnel and a 2 x 8" hole across the top.
Theo
-----Original Message-----
From: tigers-bounces+theo.smit=dynastream.com@autox.team.net
[mailto:tigers-bounces+theo.smit=dynastream.com@autox.team.net] On
Behalf Of DJoh797014@aol.com
Sent: September 12, 2008 4:06 PM
To: mgman71@comcast.net; tigers@autox.team.net
Subject: Re: [Tigers] Fw: Bell housing
There was an aold CAT tewch tip that suggested you could drill a small
hole in the bell housing in order to grease a greasable throwout
bearing.
Prehaps to PO did that. I'd just plug the hole to keep the dirrt out.
Dave
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers
http://www.team.net/archive
|