tigers
[Top] [All Lists]

Re: [Tigers] TIGER Top Install

To: "John Crawley" <alittlemoreink@hotmail.com>, "LIST TIGER"
Subject: Re: [Tigers] TIGER Top Install
From: "Sheldon Enns" <senns@wiband.ca>
Date: Wed, 17 Aug 2011 15:08:25 -0500
Hello John,

Thank you. Another lister suggested installing the hard top to line up the
windshield, so I think with these 2 pieces of information we should be able
to do a very good job.

Thank you again :),

Sheldon Enns

 -----Original Message-----
From:   tigers-bounces@autox.team.net [mailto:tigers-bounces@autox.team.net]
On Behalf Of John Crawley
Sent:   Wednesday, August 17, 2011 1:44 PM
To:     LIST TIGER
Subject:        Re: [Tigers] TIGER Top Install

Hi Sheldon:

Try . . .

http://www.tigersunited.com/techtips/JCrawleyRest/rt-JCrawleyRest19.asp


This was written some time ago but most of it is still applicable except the
part about the tension rods which were not available when I wrote the
article.
If you have any questions please drop me an -e-. One addition . . . most
tops
can be tightened a bit after they are installed by using a clothing steam
gun
on the inside but wait quite a while before you try this as they do shrink a
bit by themselves and do not over shrink.

Jc



>
> Message: 3
> Date: Wed, 17 Aug 2011 11:27:38 -0500
> From: "Sheldon Enns" <senns@wiband.ca>
> To: <Tigers@autox.team.net>
> Subject: [Tigers] Windshield & Soft-Top Installation Procedure
> Message-ID: <BMEGJMCLNAKLFMBNDEIJCEIEDDAA.senns@wiband.ca>
> Content-Type: text/plain; charset="us-ascii"
>
> Hello everyone,
>
> It's been a while since my last contribution, but I still read everyone
> else's faithfully. :-)
>
> We are getting ready to install the windshield and soft-top on our Tiger.
> When we got the car the windshield was in, and re-installation of it
should
> be straight forward, but the soft-top had been cut off and removed. Does
> anyone have comprehensive instructions for installing the windshield and
> soft-top?
>
> Would we line up the windshield and door glass first and then work on
> installing the top? We've been debating what to do for a few months now
and
> we're running out of hot days for stretching the top.
>
> Any advice would be most helpful.
>
> Thank you and have a wonderful day,
>
> Sheldon Enns
_______________________________________________

tigers@autox.team.net

Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe: http://autox.team.net/mailman/options/tigers/senns@wiband.ca
_______________________________________________

tigers@autox.team.net

Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums


<Prev in Thread] Current Thread [Next in Thread>