Joel
Unfortunately the rear brake lines are not shown with any detail.
The Alpine Parts List does show a Y connection at the rear axle but the
Tiger did not use that part.
The Tiger run a line from the 5 way connector in the engine compartment
along the right side of the drive shaft tunnel to the rubber hose. The
Rubber hose connect to a line to the right wheel cylinder then another line
runs across the axle to the left wheel cylinder. Brakes are bleed at the
left wheel cylinder only.
I put a T on the axle and ran 2 lines so I could bleed each wheel cylinder.
Ron Fraser
-----Original Message-----
From: tigers-bounces@autox.team.net [mailto:tigers-bounces@autox.team.net]
On Behalf Of Joel Martin
Sent: Thursday, March 21, 2013 3:58 PM
To: tigers@autox.team.net
Cc: Walter Jim
Subject: [Tigers] Rear Brake Line Routing
In routing of new brake lines and using the old ones for patterns, we cannot
figure out how the rear brake line from the T in the engine compartment
connects to the wheel cylinders and the rear rubber brake hose are suppose
to fit. Is there supose to be a rear T?
Please send any pictures and\or explaination of how this is supose to work.
Thanks
Joel Martin
_______________________________________________
tigers@autox.team.net
Archive: http://www.team.net/archive
Unsubscribe:
http://autox.team.net/mailman/options/tigers/rfraser@bluefrog.com
-----
No virus found in this message.
Checked by AVG - www.avg.com
Version: 2013.0.2904 / Virus Database: 2641/6194 - Release Date: 03/21/13
_______________________________________________
tigers@autox.team.net
Archive: http://www.team.net/archive
Unsubscribe: http://autox.team.net/mailman/options/tigers/mharc@autox.team.net
|