A Taste of Britain is in Rothsville, Pa. (right outside of Lancaster) on
the 25th of Aug. It's sponsored by the MG club I think. It's on a number of
websites, but I can't remember which ones right now. There is a contact
Sally Harbold. Rothsville is a very small town with a Polo field where they
hold the get together. I've never gone, so this will be my first time.
However, when I've driven to church that why over the past ten years there
are "lots" of LBC's. Some of them are just beautifully restored. That's
only an observation though while sitting at the only 2 traffic lights in
Rothsville. I would like to see a restored 250.
Dave Bjorkman ----- Original Message -----
From: "Don Malling" <email@example.com>
To: "DAVID L BJORKMAN" <firstname.lastname@example.org>
Cc: "6pack (E-mail)" <email@example.com>
Sent: Thursday, August 22, 2002 9:25 PM
Subject: Re: POR 15
> Can you give more details on "A Touch of Britan"? I couldn't find
> anything about it on the web.
> Don Malling
> DAVID L BJORKMAN wrote:
> > Andy,
> > I've been using POR-15 more as an experiment than anything else and
> > very satisfied so far. I'm restoring a 250 and using the metal prep and
> > applying the POR15. It goes on real easy and a second coat really makes
> > nice.
> > I been using a bristle brush and clean up with paint thinner. No
> > However if you get it on your skin and don't clean/wipe away quickly
> > thinner
> > you will have to let it wear off. They warn you on the can.
> > As corey said putting in smaller glass or plastic containers is a
> > idea.
> > Dave Bjorkman
> > CD5617L-Someday it will be back on the road
> > PS: anyone going to the "A Touch of Britain" in Rothsville, Pa. 3 miles
> > from my house.
> > ----- Original Message -----
> > From: "Andrew Packard" <firstname.lastname@example.org>
> > To: "6pack (E-mail)" <email@example.com>
> > Sent: Wednesday, August 21, 2002 11:14 PM
> > Subject: POR 15
> > > On July 4, I bought a "no rust" TR250 from a guy in Milwaukee and
> > back to North Carolina. After getting in and under it, there was plenty
> > body rust and lots of chassis issues including bracing and sistered
> > throughout. I have found a good TR6 frame to start from fresh. I have
> > gotten advice to use POR-15 to paint the chassis as long as I leave the
> > surface rust, wear gloves and don't get it on my face since it would
> > weeks to come off. Has anyone had experience with POR 15, good or bad?
> > > Andy