I have a wire/cable than runs straight out the side to the upper part of the
fender well. Just a ring hanging in the top of the fender well.
Larry G. Alt, President
WPA Development, LLC
219-757-3528
lalt@whiteco.com
>>> "Tarnow, Joshua" <jtarnow@lehman.com> 03/18/03 10:14AM >>>
After reading some horror stories regarding hood release failure what is the
easiest way to install a back up hood release mechanism. Also, while it
hasn't happened to me (yet) what is the best way to get into the hood should
the mechanism fail?
------------------------------------------------------------------------------
This message is intended only for the personal and confidential use of the
designated recipient(s) named above. If you are not the intended recipient of
this message you are hereby notified that any review, dissemination,
distribution or copying of this message is strictly prohibited. This
communication is for information purposes only and should not be regarded as an
offer to sell or as a solicitation of an offer to buy any financial product, an
official confirmation of any transaction, or as an official statement of Lehman
Brothers. Email transmission cannot be guaranteed to be secure or error-free.
Therefore, we do not represent that this information is complete or accurate
and it should not be relied upon as such. All information is subject to change
without notice.
|