Richard,
That is close to what I did. I put my backup release in the glove box. My
primary release is a electronic solenoid so I do not use the backup release
very often. By electronic solenoid is triggered by a small button inside
the glove box near the light.
Kyle.
-----Original Message-----
From: owner-6pack@autox.team.net [mailto:owner-6pack@autox.team.net]On
Behalf Of Richard Good
Sent: Tuesday, March 18, 2003 1:50 PM
To: Tarnow, Joshua
Cc: '6pack'
Subject: Re:
I drilled a hole in the side of the right footwell near the top and directly
in line with the cable connection point on the release lever. The original
inner cable and "T" handle goes through the hole and connects to the lever.
Of course most of the cable is extra length now and can be cut off. It is
amazing how easy it pulls. I have this as my only release but it can also be
done as an emergency release.
Richard Good
"Tarnow, Joshua" wrote:
> After reading some horror stories regarding hood release failure what is
the
> easiest way to install a back up hood release mechanism. Also, while it
> hasn't happened to me (yet) what is the best way to get into the hood
should
> the mechanism fail?
>
> --------------------------------------------------------------------------
----
> This message is intended only for the personal and confidential use of the
designated recipient(s) named above. If you are not the intended recipient
of this message you are hereby notified that any review, dissemination,
distribution or copying of this message is strictly prohibited. This
communication is for information purposes only and should not be regarded as
an offer to sell or as a solicitation of an offer to buy any financial
product, an official confirmation of any transaction, or as an official
statement of Lehman Brothers. Email transmission cannot be guaranteed to be
secure or error-free. Therefore, we do not represent that this information
is complete or accurate and it should not be relied upon as such. All
information is subject to change without notice.
|