It can be driven in by hand. Use a short piece of tubing (PVC maybe?)
slightly smaller than the outer diameter of the seal and tap it in carefully
with a mallet. It's a light press fit.
Mark Anderton
72 TR6
Virginia Beach
http://members.cox.net/andertonm/car_stuff.html
----- Original Message -----
From: <webb@daikin-america.com>
To: <6pack@autox.team.net>
Sent: Wednesday, May 07, 2003 9:48 AM
Subject: Rear trany seal
> The Bentley manual says to "press in" the rear trany seal.
>
> Can this be done using a hammer and block of wood with the trany installed
> in the car?
>
> I didn't see any earlier posts in the archives so I assume this isn't too
> difficult.
>
> Thanks, Pat
|