Good morning,
I have a quick questions. I just recieved a new wiring harness from TRF.
Are there any "tricks" or insights anyone could pass on before I jump into
this. The old harness is still in place. I've installed a new crash pad and
have the wooden portion of the dashc is out for a new piece of veneer and
refinishing. The gauges have been removed for cleaning. Should I replace
the gauges first, or am I better off re-installing the dash and then hooking
up the gauges and then installing them. Any info would be greatly
appreciated. There is finally a light at the end of the tunnel.
Thanks in advance,
John Z
'76 Tr6
DISCLAIMER:
The information transmitted is intended only for the person or entity to which
it is addressed and may contain confidential and/or legally privileged
material.
If you received this in error, please contact the sender and delete the
material
from any computer. Any review, retransmission, dissemination or other use of,
or
taking of any action in reliance upon, this information by persons or entities
other than the intended recipient is prohibited.
You have asked us to correspond with you via the Internet per e-mail. However,
the written version of our document signed by us is the only authoritative
version.
Please note that e-mail correspondence can be lost or falsified, with or
without
any interference by third persons. Conventional e-mails are not protected
against
access by third persons and, therefore, their confidentiality and/or integrity
may
not be assured. Moreover, despite our use of anti-virus software, a virus may
enter
your systems in connection with the sending of e-mails. Thus, we are not liable
for
any damages resulting out of these circumstances.
/// 6pack@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|