Front inner bearing orientation

["james mc arthur" <jrmcarthur@verizon.net>]

    Good morning to all! I am putting the TR6 front rotors back on, after 
receiving them from the shop that resurfaced them and ran into a snag. The 
"bearing shield" and felt washer are one piece. Does the felt face towards 
the bearing or in the opposite direction? In other words, when I look at the 
rear of the rotor, will I see the felt or the steel lip? I am on hold until 
I sort this out. Bentley's is not clear on this point. Thanks to 
all!..........Jim McArthur @ jrmcarthur@verizon.net