A common error is to not realize that there is already a seal in that cavity
and try and insert a second one. That is guaranteed to leak. If you are
getting leaks after adding the seal, triple check that there is not already a
seal in there, remove it and use the new seal.
The easiest way to check is to poke it with a sharp instrument, you should hit
metal. If not, it is probably an old petrified seal.
Stan
-----Original Message-----
From: 6pack-bounces+stan.foster=hp.com@autox.team.net
[mailto:6pack-bounces+stan.foster=hp.com@autox.team.net] On Behalf Of Stuart
Thompson
Sent: Friday, December 21, 2007 12:42 PM
To: lfm614@aol.com
Cc: 6 Pack list
Subject: Re: [6pack] Spin-On Adapter
> Its a square crossection (round) ring right?
Yes
>You're supposed to change it to get a fresh, non-compressed seal for the
>cannister.
I am??
>You've been very fortunate.
I'll say!
The people at the oil & lube shop have tried to install it before but it
always leaked.
They take it out and it stops leaking. I have never used one and it hasn't
leaked a drop
of oil (from the canister) in almost 5 years of ownership.
I'll take a closer look next time and see what I am missing.
Stuart Thompson
_______________________________________________
_______________________________________________
Support Team.Net http://www.team.net/donate.html
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
|