Sorry should have said shims for the slightly "smaller" caliper bolts.
--------------------------------------------------
From: "Timothy Holbrook" <tjh173@yahoo.com>
Sent: Saturday, February 7, 2015 6:58 PM
To: "6Pack List" <6pack@autox.team.net>
Subject: [6pack] Refiring my TR6
> Hi everyone,
> After four years in storage (my eldest son is now almost three and a half
> years old, so you understand why the Triumph as gone on the backburner!),
> it's
> time to get the my '71 TR6 back on the road.
> I'm planning to do a quick rebuild of the carbs and fuel pump (I'm sure
> time
> and that darned ethanol-blend fuel hasn't been kind to them), as well as
> replace the rear wheel cylinders (seals appear to be shot, as brake pedal
> goes
> to floor and there is a little puddle under each rear wheel).B Will also
> buy
> a new brake master cylinder in case that's shot.
>
> Couple of questions for the list:
> 1. In the past when the car has sat for a long time, I have spun the
> engine
> with the starter for a while before firing, to get the oil circulated.B
> To
> reduce strain on the "dry" engine when doing this, I have removed the
> spark
> plugs and removed the rocker shaft, so that the engine can spin with very
> little resistance.B However, my dad recommended just removing the
> distributor
> and pulling the cam gear out, and just spinning the oil pump with a
> drill.B
> Is that possible in a TR6?B I'm not clear how I'm going to connect my
> drill
> to the oil pump.B If I remember right, the shaft that goes from the cam
> gear
> to the oil pump is press-fit into the cam gear, so it's not like I can
> connect
> it to my drill.B Any thoughts?
> 2. I remember reading that there are 0.75" rear wheel cylinders available
> which give slightly better braking performance, especially when paired
> with
> the Toyota 4-pot front calipers (which I may do in the near future).B
> Where
> do we get these 0.75" wheel cylinders?
>
> 2. I may need to replace the clutch master cylinder.B Should I go with
> the
> 0.70" or 0.75" bore?B I understand the 0.75 will give me higher pedal
> pressure but more movement of the slave, which seems a good idea
> considering
> how close the tolerances are with clutch-throw on these cars.B What do
> you
> all think?B B
> 3. Anyone have any experience with these new "nitrophyl" carb floats that
> I
> see on Moss's website?B They are apparently a solid float instead of
> hollow,
> thus the problem of a hole in the float is eliminated.B Seems like a neat
> idea while the carbs are being rebuilt.
> Thanks all,
> Tim Holbrook1971 TR6 (hopefully back on the road this spring!)
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation $12.96
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
>
> 6pack@autox.team.net
> http://autox.team.net/mailman/listinfo/6pack
>
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/6pack/glemon@neb.rr.com
_______________________________________________
Archive: http://www.team.net/archive
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
|