alpines
[Top] [All Lists]

Re: Using POR-15

To: Dan Eiland <deiland1@elp.rr.com>
Subject: Re: Using POR-15
From: jumpinjan <jservaites@woh.rr.com>
Date: Sun, 22 Sep 2002 17:23:49 -0700
Dan,
        It sounds like you're planning to put a lot of man-hours in the
restoration and you said that this is your first attempt at a
restoration. I'm a little confused as to why you are applying POR-15
products. POR-15 is not that good a product to keep rust away and it's
pretty expensive. I highly recommend that you apply only epoxy primer on
all the bare metal areas. As a top coat, I recommend a single stage
urethane. When you replace the rusted out sheet metal, replace it with
the same gauge metal (usually 20 gauge).  You want to treat the rusty
areas with a rust converter like Picklex 20
(http://www.autobodystore.com/r-o-n.htm). The rest of the clean metal
should be treated with a metal conditioner. For an epoxy, to fill the
rust pin holes, I use a high quality epoxy called Marine-Tex. It is very
strong and sands nice. My final comment is why didn't you have the body
dipped? The price may seem expensive, but it is well worth it. It hard
to stop the rust if one doesn't dip the body.
Jan



-- 
   ______  ______  _______
  / ____/ / ____/ / ___  / 
 / /___  / /___  / /__/ /   _|  _   _  .  _   _   _
/___  / /___  / / __  _/   (_|_(/_ /_)_|_(_|_| )_/_)
___/ / ____/ / / /  \ \                   _|
____/ /_____/ /_/    \_\http://www.ssrdesigns.com

<Prev in Thread] Current Thread [Next in Thread>