Sorry to disagree but as I read "The Book" 13.2 G says
Roll bars may be welded. Roll cages must be bolted, not
welded. A roll cage has more than 4 attachment points
or has bracingboth fore and aft of the main hoop
Richard Pilfold -C.S.C.C. BSP 240Z
"rpilfold@gdmoore.com"
> -----Original Message-----
> From: Josh Hadler [SMTP:jhadler@rmi.net]
> Sent: Thursday, November 11, 1999 3:10 PM
> To: Talus9998@aol.com
> Cc: autox@autox.team.net
> Subject: Re: Roll Bar and Removal of Rear seats
>
> Talus9998@aol.com wrote:
> >
> > This is a question for all the SP guys. Are there any regulations on
> roll
> > bars in SP???
>
> Yes, it must be bolt in. Because your car (civic) is not considered
> an
> open top car, that is the only requirement you must meet that is
> specific to roll bars. However, you may not perform any unauthorized
> modifications to install it. Removal of interior upholstery or panels to
> install a roll bar isn't allowed.
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
|