Terry does do an update, it involves welding a reenforcement bar to part
of the regulator after bending it back to where it should be. I believe
he has a sheet with the correct measurements, although it is a bit tricky.
In the worst case, the door itself might be warping in which case you're
getting into serious refurbishment money.
On Mon, 9 Aug 1999, Fedeli, Joe wrote:
> I know I've read this before, but did not save the $%#@ article. What is
> the corrective action or after market update that one of the Bricklin
> members has to the window regulators? You all know the problem. The window
> rolls down properly, but when rolling the window back up, it does not
> 'shift' properly back up the channel and the 'back' of the window leaves a
> space unless you 'hand grasp the window' and assist it back into place. Has
> anyone done some modifications to correct this problem? Does Terry or Bob's
> Brick have a 'replacement update' for this factory defect? Any one else?
> Thanks!
>
> Joe
>
------------------------------------------------------------------------
I am Pentium of Borg, precision is futile,
you will be approximated...
_____ . .
' \ . . |>>
O// . . |
_\ . . . |
| | . . . . |
/ | . sbepko@bcpl.net . . . |
/ .| Baltimore, MD. . ....o |
-------------------------------------------------------------------------
|