Anyone know exactly how to bleed the brakes? I can't get any pressure to the
rear. I disconnected the line from the proportioning valve and nothing comes
out so it looks like that's the problem. The master cylinder is new and I
bleed it before hooking it up. The manual says something about holding out a
pin on the end of the valve. I didn't have to do this for the front brakes.
Also, the front connection is leaking where the line goes into the caliper.
I have new lines and calipers that apear identical to the originals. Is
there supposed to be a washer on the connection or is it a pressure fit? It
may be that the holes in the caliper are too deep.
Marvin May
#1343
|