Hi all. Well I just about destroyed my driverside door skin removing it from
the frame. I don't feel all that bad because the skin was in pretty bad
shape to begin with and it has been worked on before. Question: Are there
supposed to be rivets on the top portion of the panel where it bends over
near the top of the window? I am going to have to remove the skin from the
passengerside door as well and I want to be prepared. Also the interior of
the door is covered in rust. Obviously I will have to clean it up and get it
ready to be painted. What type of paint or sealant should I use to paint the
interior of the door. I did buy a can of POR15. Should I just use that and
leave it or should I use something else?
Thanking everyone in advance,
Kevin vin# 1911
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/bricklin
|