Dave,
Have you come up with a solution to this problem. I installed a MSD box and
had the tach hooked up to the original location and thought that I just fried
my tach (because of the multiple spark issue). I ended up adding an
aftermarket monster tach....
I would like to have use of my tach again...if it is still possible.
Thanks
Jamison
In a message dated 7/7/2003 10:52:23 AM Eastern Standard Time, dcp125@juno.com
writes:
>
>
> Has anyone tried to connect their Tach with an MSD Ignition System?
>
> The (MSD) instructions say to connect it to the "Box" but I didn't get any
>readings from the Tach. When I connect to the coil (as you would on a stock
>ignition) the Tach works but when you put the car in gear, it will stall and
>not start unless you disconnect the Tach.
>
> Anyone had this happen? What did you do to fix it?
>
> Dave
> #569
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/bricklin
|