Re: Heater box alignment

[Maycinc@cs.com]

I did the same thing.  I couldn't get Terry's brackets to work and I didn't 
like the misalignment of the defroster.  I think the fabricated ducting is a 
better way to go.
Marvin
#1343

In a message dated 5/1/2005 6:15:19 PM Mountain Daylight Time, 
colemaal@hotmail.com writes:


> I did not feel like going through the problems of relocating the box, so I 
> made a connector from a couple of pieces of sheet aluminum and some flexible 
> dryer ducting.
> 
> ALan Coleman
> #246 (original owner)