At 05:46 PM 5/15/2016, sven koch wrote:
>the 4 screws of the mounting plate for the front wheel. Getting everything
>together was not a big challenge, but now my question is how to
tight/ adjust the
>wheel bearing.
Sven,
Quoting from the Chilton's AMC manual,
"Place the hub assembly onto the spindle and install the inner
lockring and outer bearing. Install the wheel bearing nut and torque
it to 50 Ft Lb, while turning the wheel back and forth to seat the
bearings. Back off the nut about 1/4 turn (90deg) max."
John
John T. Blair WA4OHZ email: jblair1948@cox.net
Va. Beach, Va Phone: (757) 495-8229
48 TR1800 48 #4 Midget 65 Morgan 4/4 Series V (B1106)
75 Bricklin SV1 (#0887) 77 Spitfire 71 Saab Sonett III
65 Rambler Classic
Morgan: www.team.net/www/morgan
Bricklin: www.bricklin.org
If you can read this - Thank a teacher!
If you are reading it in English - Thank a Vet!!
From Dennis Prager - The American Trilogy:
e pluribus Unum, "from many, one."
In God We Trust
Liberty - the power of choosing, thinking, and acting for
oneself; freedom from control or restriction
---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
_______________________________________________
Bricklin@autox.team.net
Archive: http://www.team.net/archive
|