I had one with a T-5 5speed trans and it fit fine.
Will Parris
James R Bown wrote:
>
> I have a question concerning 215 Buick/Oldsmobile bellhousings (Clutch
> Housings). I recently acquired a TransDapt aftermarket bellhousing. This
> TransDapt bellhousing measures approx. 5/8" shorter than a factory
> Buick/Olds bellhousing. The engine side matches up to a 215 perfectly. The
> transmission side matches up perfectly with a GM Saginaw 4-speed. The
> problem is that the input shaft sticks out 5/8" too far. How would it be
> possible to use this shorter bellhousing? Is there some variety of
> transmissions with a 5/8" shorter input shaft that this bellhousing was
> designed for? Or are you supposed to use some type of additional spacer?
> Any input or ideas is appreciated.
> Regards,
> Jim B.
> Bowan@uswest.net
|