| To: | a roadster list <datsun-roadsters@autox.team.net> |
|---|---|
| Subject: | Re: Hub torque spec? |
| From: | Toby B <toby@wolfenet.com> |
| Date: | Wed, 10 Feb 1999 13:42:50 -0800 |
About 0 ft-lbs.
or just snug enough to get all play out of the bearings, but not so
much that you can't (with effort) slide the locking washer that's behind
the nut. A little loose is safer for the bearings than a little too
tight!
Toby
Stephen Swearingen wrote:
>
> What's the torque spec for the nut that goes on the spindle?
>
> Thanks
> Steve
> 69 2000
|
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: datsun sp310, Toby B |
|---|---|
| Next by Date: | looking for 66 or 67 body, thorn |
| Previous by Thread: | Hub torque spec?, Stephen Swearingen |
| Next by Thread: | Re: Hub torque spec?, WayneLoom |
| Indexes: | [Date] [Thread] [Top] [All Lists] |