| To: | datsun-roadsters@autox.team.net |
|---|---|
| Subject: | A little help! |
| From: | KWS711@aol.com |
| Date: | Fri, 10 Sep 1999 21:11:16 EDT |
Pulled the rear axles out of my 68 2000 SU to replace the wheel brgs etc. Went to pull the bearing collar off but couldn't get it to budge. Used a clam shell type puller, but even with heat, it wouldn't move. Any suggestions or tricks to this removal? Also, is the bearing spacer on the wheel side of the bearing a press or clearance fit? Thanks for your help!!! Kim |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: My new rear end!!!, 70 - SPL311 |
|---|---|
| Next by Date: | RE: butt-ugly dashes-Fan the Flames, Jim Tyler |
| Previous by Thread: | Crazy PO stuff, Kyle Hagemann |
| Next by Thread: | Re: A little help!, Toby B |
| Indexes: | [Date] [Thread] [Top] [All Lists] |