I know - this subject is like the alternator one - it LIVES!
Ben sent me the dimensions of the oil drain-back tube as ½ dia. by 3 5/8
long. I made a tube using these dimensions. The tube goes to the bottom of
the hole ( about an inch deep) before it gets tight. This makes the tube
seem too short. The hole has two diameters - the top part is .540 inches
and then it steps down to .500 after about ½ inch deep. Question - is the
tube supposed to fit in the top portion of the hole or bottom?
Any help would be greatly appreciated - thanks.
Phil
SEROC
|