Speaking of sealant. When I had my radiator recored many moons ago the guy
(my roomies brother) showed me a stack of cores and in almost each and every
core bottom were globs of silicone sealer. He didn't have to say more. I
never use silicone as a sealant. I use Formagasket Part No. 1B or something
like that and use it sparingly.
FWIW,
'66 Mike
----- Original Message -----
From: noji <noji@snowman.med.umn.edu>
To: Dan Neuman <dneuman@stars.sfsu.edu>
Cc: <datsun-roadsters@autox.team.net>
Sent: Thursday, June 29, 2000 12:46 PM
Subject: Re: Well I did it again... yet another cracked thermostat housing
> Daniel,
>
> The thermostat sits in a slot in the housing. Because it sits sideways it
has the
> potential to move out of position during the time that you insert the
thermostat and
> secure the bolts. Because everything is not flush you can get a lea and
when you
> over tighten the bolts you can crack the housing. You can use a little
gasket sealer
> on the thermostat to prevent it moving out of position.
>
> Dana
>
> Dan Neuman wrote:
>
> > Hello All,
> > Got the new rad in got both new temp senders in.. put it all
back
> > toghether and filled the rad... Bit of water leaking out around the
elbow..
> > tighten down nuts a bit more and CRACK!!!!!!!!!!!! I managed to once
again
> > crack the $&@%$!@#@^!%#^%&^!%$^@!!*!*&@^$*%!!*#@^%!!@* !*#V !@*&#!
> > elbow... SInce I have already done this I thought I was being carefull..
What did
> > I do wrong??
> >
>
|