I thought the rear harness needs to be center mounted behind the seat with
that type of setup. I never saw it mounted to the side before on any race
car I've ever seen.
Sparco should make an adaptor kit to mount the harness to the roll bar.
----- Original Message -----
From: "alvin gogineni" <firstname.lastname@example.org>
Sent: Wednesday, September 18, 2002 2:51 AM
Subject: Sparco seatbelts, grant steering wheel pics
> Everything was going smooth until I had to mount the shoulder harness.
> lap belts bolted up fine. I thought I would bolt the third point on the
> fender hump, where the high windshield cars do so. I checked, and there
> indeed a hole beneath the vinyl, but it wasn't threaded or deep enough, so
> I'm SOL. So post '67.5 cars only have this hole threaded for belts? In
> meantime I'll use the lap belts. Check out the pics. Peace
> Chat with friends online, try MSN Messenger: http://messenger.msn.com
> /// email@example.com mailing list
> /// Send admin requests to firstname.lastname@example.org or go to
> /// http://www.team.net/cgi-bin/majorcool
> /// Archives at http://www.team.net/archive
> /// Send list postings to email@example.com
/// firstname.lastname@example.org mailing list
/// Archives at http://www.team.net/archive